Switch the printer off and on before attempting to print again.Īccording to your printer, there is dirt on the drum unit and you should follow the drum cleaning steps included in your printer guide. Whether the fuser unit is too hot or not hot enough, a fuser unit failure has occurred. The transfer belt is in need of replacement having reached the end of it's life cycle. To avoid deterioration of print quality, seek assistance from an engineer.Ī paper jam has occurred in the duplex unit meaning the paper has jammed during double-sided printing. The laser unit needs to be replaced as it's reached it's life cycle end. An engineer will be able to assist you with this.
The fuser unit needs to be replaced as it's reached its life cycle end. The feed roller and separation pad for the main feed tray may need to be replaced.
#Brother gt 541 battery manual
The feed roller and separation pad for the manual feed tray may need to be replaced. The drum unit needs to be replaced as it's reach the end of it's life cycle. Used to check the print density, the density sensor has developed a fault and can be resolved by switching the machine off and on.Īn issue has arisen with the density sensor shutter. Used to write the information to be printed onto the drum surfaces, there has been a laser diode failure. Try switching the printer off and on or seek a replacement fan if the problem persists. There has been a malfunction of the main motor which drives all of the printing functions.
There has been a malfunction of the laser motor with the spinning mirror and motor itself developing a fault. Try switching the printer off and on again. There has been a malfunction of the laser unit and the laser beam is not being detected. Switch the machine off for 5 minutes then on again. There has been a malfunction of the fuser unit and the temperature, in particular.
This section lists error messages and error codes shown in the Control Panel display, and solutions for the errors.
0 kommentar(er)
